Toyota Camry Manual page 651

BO–100
BODY – SLIDING ROOF
Adjust by loosening the sliding roof installation nuts
and readjust the sliding roof to the proper position.
SLIDING ROOF REMOVAL
1. DISCONNECT BATTERY CABLE FROM NEGATIVE
TERMINAL
CAUTION: Work must be started after. 90 seconds from
the time the ignition switch is turned to the "LOCK"
position and the negative (–) terminal cable is discon–
nected from the battery.
2. REMOVE SLIDING ROOF SWITCH
(a) Using a screwdriver, remove the cover.
HINT: Tape the screw driver tip before use.
(b) Remove 2 screws and the switch, then disconnect the
connectors.
3. REMOVE FOLLOWING PARTS:
(a) Inner rear view mirror
(b) Sunvisors and holders
(c) Front assist grip
4. REMOVE FRONT PILLAR GARNISH
(a) Sedan, Wagon: Remove the 2 clips by hand.
(b) Sedan, Wagon: Pull the garnish rearwards to remove
it.
(c) Coupe: Rear side garnish must be removed before
front piller garnish.
5. REMOVE FRONT SIDE OF ROOF HEADLINING
(a) Disconnect the front side of roof headlining from the
front side of housing.
(b) Pull down the front side of roof headlining by hand.