Toyota Camry Manual page 635

BO–84
BODY – BACK WINDOW GLASS
9. REMOVE BACK WINDOW MOULDING
Using a knife, cut off the moulding as shown.
NOTICE: Do not damage the body with the knife.
10. REMOVE BACK WINDOW GLASS
Remove the glass in the same manner as windshield.
(See step 8 on page BO–77)
11. REMOVE RETAINERS
Remove retainers from the body.
BACK WINDOW GLASS INSTALLATION
1. CLEAN AND SHAPE CONTACT SURFACE OF BODY
(See step 1 on page BO–77)
2. REPLACE LOWER MOULDING CLIP
(a) Remove the screw and the damaged clip.
(b) Install the new clip with the screw.
3. CLEAN REMOVED GLASS
(See step 3 on page BO–77)
4. REMOVE STOPPERS
Using a knife, remove the stoppers.
5. POSITION GLASS
(See step6 on page BO–77)
6. CLEAN CONTACT SURFACE OF GLASS
(See step 7 on page BO–78)
7. INSTALL DAM
Install the dam with double–stick tape as shown in
the drawing.
NOTICE: Do not touch the glass face after cleaning it.
8. COAT CONTACT SURFACE OF BODY WITH
PRIMER 'M'
(See step 9 on page BO–79)