Toyota Camry Manual page 391

BE–72
BODY ELECTRICAL SYSTEM
BRAKE FLUID LEVEL WARNING SWITCH
INSPECTION
INSPECT BRAKE FLUID LEVEL WARNING SWITCH
(a) Remove the reservoir tank cap and strainer.
(b) Disconnect the connector.
(c) Check that there is no continuity between terminals
with the switch OFF (float up).
(d) Use syphon, etc. to take fluid out of the reservoir tank.
(e) Check that there is continuity between terminals with
the switch ON (float down).
(f) Pour the fluid back in the reservoir tank.
If operation is not as specified, replace the switch.
PARKING BRAKE SWITCH INSPECTION
INSPECT PARKING BRAKE SWITCH
(a) Check that there is continuity between terminal and
switch body with the switch ON (switch pin released).
(b) Check that there is no continuity between terminal
and switch body with the switch OFF (switch pin
pushed in).
If operation is not as specified, replace the switch or
inspect ground point.
LIGHT FAILURE WARNING LIGHT
INSPECTION
INSPECT LIGHT FAILURE WARNING LIGHT
(a) Disconnect the connector from the light failure sensor
and ground terminal 4 on the wire harness side con–
nector.
(b) Start the engine, check that the warning light lights
up.
If the warning light does not light up, test the bulb or
inspect wire harness.
– COMBINATION METER