Toyota Camry Manual page 885

BRAKE SYSTEM – FRONT BRAKE(2–Piston Type)
7. INSTALL NEW PADS
(a) Install the pad wear indicator plate on the pad.
(b) Apply disc brake grease to both sides of the inner
anti–squeal shim.
(c) Install the 2 anti–squeal shims on each pad.
(d) Install the inner pad with the pad wear indicator plates
facing upward.
(e) Install the outer pad.
NOTICE: There should be no oil or grease adhering to the
friction surface's of the pads or the disc.
(f) Install the 2 anti–squeal springs.
8. INSTALL CALIPER
(a) Draw out a small amount of brake fluid from the
reservoir.
(b) Press in the piston with a hammer handle or similar
implement.
HINT: If the piston is difficult to push in, loosen the
bleeder plug and push in the piston while letting some
brake fluid escape.
(c) Install the caliper.
(d) Hold the sliding pin and torque the installation bolt.
Torque: 34 N .m (350 kgf–cm, 25 ft–lbf)
9. INSTALL FRONT WHEEL
10. CHECK THAT FLUID LEVEL IS AT MAX LINE
CALIPER REMOVAL
1. DISCONNECT FLEXIBLE HOSE
(a) Remove the union bolt and 2 gaskets from the caliper,
then disconnect the flexible hose from the caliper.
(b) Use a container to catch the brake fluid as it drains
out.
BR–199