Toyota Camry Manual page 474

BODY ELECTRICAL SYSTEM
MOTOR ANTENNA REMOVAL AND
INSTALLATION
1. REMOVE MOTOR ANTENNA
(a) Remove the antenna nut.
(b) Remove the RH side cover.
(c) Disconnect the motor antenna connector.
(d) Remove the nut and the motor antenna assembly.
(e) Disconnect the antenna cord.
(f) Remove the drain hose.
2. INSTALL MOTOR ANTENNA
(a) Connect the motor antenna connector and the anten–
na cord.
(b) Install the antenna nut.
(c) Install the nut.
(d) Connect the drain hose.
ANTENNA ROD REMOVAL AND
INSTALLATION
1. REMOVE ANTENNA ROD
HINT: Perform this operation with the battery nega–
tive (–) cable connected to the battery terminal.
(a) Turn the ignition switch to "LOCK" position.
(b) Remove the antenna nut.
(c) Press the 'AM' or "FM" button on the radio receiver,
and simultaneously turn the ignition switch to "ACC"
position.
HINT:
The rod will extend fully and be released from the
motor antenna.
After removing the antenna rod, leave the igni–
tion switch at "ACC".
NOTICE: To prevent body damage when the antenna rod
Is released, hold the rod while It comes out.
– AUDIO SYSTEM
BE–155