Toyota Camry Manual page 824

BR–138
INSPECTION PROCEDURE
Check voltage between terminals and E1 of DLC1.
Check for open and short in harness and connector between ABS ECU
and DLC1, DLC1 and body ground (See page
Check and replace ABS ECU.
BRAKE SYSTEM – ANTI–LOCK BRAKE SYSTEM (ABS)
1. Turn ignition switch ON.
2. Measure voltage between terminals Ts and E1
of DLC 1.
Voltage: 10–14 V
If ABS warning light does not blink even after Ts
and E1 are connected, the ECU may be defective.
Repair or replace harness or connector.
).
IN–28