Toyota Camry Manual page 557

BO–6
BODY – GENERAL INFORMATION
SRS (Supplemental Restraint System)
The 1994 CAMRY is equipped with an SRS, such as
the driver airbag and front passenger airbag assembly.
Failure to carry out service operations in the correct
sequence could cause the SRS to deploy, possibly
leading to a serious accident.
When removing or installing, refer to the pre–
cautionary notices in the RS section before perform–
ing the operation.
Work must be started after 90 seconds from the
time the ignition switch is set to the LOCK posi–
tion and the negative (–) terminal cable is dis–
connected from the battery.
(The SRS is equipped with a back–up power
source so that if work is started within 90 sec–
onds of disconnecting the negative (–) terminal
cable from the battery, the SRS may deploy.)
To avoid erasing the memory of each memory
system, never use a back–up power supply from
outside the vehicle.
Before repairs, remove the airbag sensors if
shocks are likely to be applied to the sensors
during repairs.
The front airbag sensor set bolt has been anti–
rust treated. When the sensor is removed, always
replace the set bolt with a new one.
If the front airbag sensors, center airbag sensor
assembly, steering wheel pad or front passenger
airbag assembly have been dropped, or if there
are cracks, dents or other defects in the case,
bracket or connector, replace them with new
ones.
Never use SRS parts from another vehicle. When
replacing parts, replace them with new parts.
Do not expose the front airbag sensors, center
airbag sensor assembly, steering wheel pad or
front passenger airbag assembly directly to hot
air or flames.
The SRS wire harness is integrated with the cowl
wire harness assembly. The wires for the SRS
wire harness are encased in a yellow corrugated
tube. All the connectors for the system are also a
standard yellow color. If the SRS wire harness
becomes disconnected or the connector bec–
omes broken due to an accident, etc., repair or
replace it. (See RS section)