Toyota Camry Manual page 618

BODY – BODY OUTSIDE MOULDING
3. HEAT MOULDING
Using a heat light, heat the moulding to 20 – 30_ C (68_– 86_ F)
NOTICE: Do not heat moulding excessively.
The temperature should not be higher than 80
4. APPLY ADHESIVE TO DOOR OUTSIDE MOULDING
Apply adhesive to both punched out ends of the
moulding.
NOTICE: Install the moulding within 30 minutes after
applying the adhesive.
Part No. 08850–00051
5. LIFT MOULDING RELEASE SHEET FROM FACE OF
MOULDING
NOTICE: When the moulding release sheet is removed, be
sure that no dirt or dust can get onto the uncoverd area.
6. INSTALL MOULDING
Align the bosses an the moulding with the body holes,
and push the moulding to the body.
NOTICE:
Be sure that the body and moulding are heated to
the proper temperature.
Do not depress the adhesive – coated parts ex–
cessively just hold them down with your thumb.
Scrape off any overflowing adhesive with a plastic
spatula and clean the surface with a dry rag.
After installation, do not wash the vehicle for 24
hours.
BO–67
_ _
C (176 F).