Toyota Camry Manual page 182

INSPECTION PROCEDURE
Check voltage between terminal OD1 of ECM connector and body
ground.
Check voltage between terminal OD of cruise control ECU harness side con–
nector and body ground.
Check harness or connector between cruise control ECU and ECM
(See page
'OK
Check and replace ECM.
AUTOMATIC TRANSAXLE
IN–31
).
– TROUBLESHOOTING
Turn ignition switch ON.
Measure voltage between terminal 01 31 of ECM
connector and body ground.
Voltage: 10–14 V
Proceed to next circuit inspection shown
on matrix chart (See page AX1–68).
(1) Disconnect cruise control ECU connector.
(2) Turn ignition switch ON.
Measure voltage between terminal OD of cruise
control ECU harness side connector and body
ground.
Voltage: 10–14 V
Check and replace cruise control ECU.
Repair or replace harness or connector.
AX1–109