Toyota Camry Manual page 247

AX2–60
AUTOMATIC TRANSAXLE –
VISUAL CHECK AND CONTACT PRESSURE CHECK
(a) Disconnect the connectors at both ends.
(b) Check for rust or foreign material, etc. in the terminals
of the connectors.
(c) Check crimped portions for looseness or damage and
check if the terminals are secured in the lock portion.
HINT: The terminals should not come out when pulled
lightly.
(d) Prepare a test male terminal and insert it in the female
terminal, then pull it out.
NOTICE: When testing a gold–plate female terminal,
always use a gold–plated male terminal.
HINT: When the test terminal is pulled out more easily
than others, there may be poor contact in that section.
CONNECTOR HANDLING
When inserting tester probes into a connector, insert
them from the rear of the connector. When necessary,
use mini test leads. For water resistant connectors
which cannot be accessed from behind, take good
care not to deform the connector terminals.
TROUBLESHOOTING