Toyota Camry Manual page 719

BRAKE SYSTEM – FRONT BRAKE(2–Piston Type)
4. REMOVE SLIDING PINS AND DUST BOOTS
(a) Remove the 2 sliding pins from the torque plate.
(b) Using a screwdriver and hammer, tap out the 2 dust
boots.
FRONT BRAKE COMPONENTS
INSPECTION AND REPAIR
1. MEASURE PAD LINING THICKNESS
Using a ruler, measure the pad lining thickness.
Standard thickness:
11.0 mm (0.433 in.)
Minimum thickness:
1.0 mm (0.039 in.)
Replace the pad if the pad's thickness is at the mini–
mum thickness or less, or if the pad has excessively
uneven wear.
2. MEASURE DISC THICKNESS
Using a micrometer, measure the disc thickness.
Standard thickness:
28 mm (1.102 in.)
Minimum thickness:
26 mm (1.024 in.)
Replace the disc if the disc's thickness is at the mini–
mum thickness or less. Replace the disc or grind it on
a lathe if it is badly scored or worn unevenly.
3. MEASURE DISC RUNOUT
Measure disc runout 10 mm (0.39 in.) from the outer
edge of the disc.
Maximum disc runout:
0.05 mm (0.0020 in.)
If runout is greater than maximum, attempt to adjust
to below this maximum figure.
BR–33