Toyota Camry Manual page 708

BR–22
BRAKE SYSTEM – FRONT BRAKE(Single–Piston Type)
2. INSPECT PAD LINING THICKNESS
Check the pad thickness through the caliper inspec–
tion hole and replace the pads if it is not within the
specification.
Minimum thickness:
1.0 mm (0.039 in.)
3. LIFT UP CALIPER
(a) Hold the sliding pin on the bottom and loosen the
installation bolt.
(b) Remove the installation bolt.
(c) Lift up the caliper and suspend the caliper with string.
HINT: Do not disconnect the flexible hose from the
caliper.
4. REMOVE FOLLOWING PARTS:
(a) 2 anti–squeal springs
(b) 2 brake pads
(c) 4 anti–squeal shims
(d) 1 MZ–FE engine:
Pad wear indicator
(e) 4 pad support plates
5. CHECK DISC THICKNESS AND RUNOUT
(See page BR–26)