Toyota Camry Manual page 127

AX1–54
AUTOMATIC TRANSAXLE –
PRELIMINARY CHECK
1. CHECK FLUID LEVEL
HINT:
Drive the vehicle so that the engine and transaxle
are at normal operating temperature.
Fluid temp.: 70–80 C (158–176 F)
Only use the COOL range on the dipstick as a
rough reference when the fluid is replaced or the
engine does not run.
(a) Park the vehicle on a level surface and set the parking
brake.
(b) With the engine idling and the brake pedal depressed,
shift the shift lever into all positions from P to L
position and return to P position.
(c) Pull out the oil level gauge and wipe it clean.
(d) Push it back fully into the tube.
(e) Pull it out and check that–the fluid level is in the HOT
range.
If the level is at the low side, add fluid.
Fluid type:
ATF DEXRON
NOTICE: Do not overfill.
2. CHECK FLUID CONDITION
If the fluid smells burnt or is black, replace it.
3. REPLACE TRANSAXLE FLUID
(a) Using SST, remove the drain plug and drain the fluid.
SST 09043–38100
(b) Reinstall the drain plug securely.
(c) With the engine OFF, add new fluid through the oil
filler tube.
Fluid type:
ATF DEXRON^II
Capacity:
Total: 5.6 liters (5.9 US qts, 4.9 Imp. qts)
Drain and refill: 2.5 liters (2.6 US qts. 2.2 Imp. qts)
(d) Start the engine and shift the shift lever into all posi–
tions from P to L position and then shift into P posi–
tion.
(e) With the engine idling, check the fluid level. Add fluid
up to the COOL level on the dipstick.
(f) Check the fluid level at the normal operating tempera–
ture 70–80 C (158–176 F) and add as neces–
sary.
NOTICE: Do not overfill.
4. CHECK FLUID LEAKS
Check for leaks in the transaxle.
If there are leaks, it is necessary to repair or replace O
–rings, seal packings, oil seals, plugs or other parts.
TROUBLESHOOTING
_
II