Toyota Camry Manual page 612

BODY – WIPER AND WASHER
REAR WIPER INSTALLATION
ASSEMBLE REAR WIPER PARTS BY FOLLOWING RE–
MOVAL SEQUENCE IN REVERSE
INSTALL REAR WIPER ARM
(a) Install 2 washers with 2 nuts.
Torque: 11 N .m (110 kgf–cm, 8 ft–Ibf)
(b) Install the wiper arm and operate the wiper once and
turn the wiper switch OFF.
(c) Adjust the installation position of the wiper arm to the
position shown in the installation.
(A) Approx. 20 mm (0.79 in.)
(d) Torque the nut.
Torque: 5.4 N–m (55 kgf–cm, 48in.–lbf)
REAR WASHER NOZZLE ADJUSTMENT
1. INSPECT REAR WASHER NOZZLE
While operating the washer, check whether the point
where the washer fluid hits the back door glass and
the upsurge area are with in the range indicated by the
hatched line.
(A)Approx. 600 mm (23.62 in.)
(B)Approx. 200 mm (7.84 in.)
2. ADJUST FRONT WASHER NOZZLE
Using a tool like that shown in the installation, change
the direction of the nozzle hole to adjust the point
where washer fluid strikes the windshield.
BO–61