Toyota Camry Manual page 108

AUTOMATIC TRANSAXLE –
(b) Install SST so that it fits in the notch of the converter
hub and outer race of the one–way clutch.
SST 09350–32014 (09351–32020)
(c) With the torque converter clutch standing on its side,
the clutch locks when turned counterclockwise, and
rotates freely and smoothly clockwise.
If necessary, clean the converter clutch and retest the
clutch.
Replace the converter clutch if the clutch still fails the
test.
2. MEASURE DRIVE PLATE RUNOUT AND INSPECT
RING GEAR
Set up a dial indicator and measure the drive plate
runout.
If runout exceeds 0.20 mm (0.0079 in.) or if the ring
gear is damaged, replace the drive plate. If installing a
new drive plate, note the orientation of spacers and
tighten the bolts.
Torque: 83 N–m (850 kgf–cm, 61 ft–lbf)
3. MEASURE TORQUE CONVERTER CLUTCH SLEEVE
RUNOUT
(a) Temporarily mount the torque converter clutch to the
drive plate. Set up a dial indicator.
If runout exceeds 0.30 mm (0.0118 in.), try to correct
by reorienting the installation of the converter. If ex–
cessive runout cannot be corrected, replace the
torque converter clutch .
HINT: Mark the position of the converter clutch to
ensure correct installation.
(b) Remove the torque converter clutch.
ASSEMBLY REMOVAL AND INSTALLATION
AX1–35