Toyota Camry Manual page 405

BE–86
BODY ELECTRICAL SYSTEM
Illumination
(a) Set the window lock switch to the unlock position.
(b) Connect the positive (+) lead from the battery to
terminal 7 and the negative (–) lead to terminal 1,
check that all the illuminations light up.
(c) Set the window lock switch to the lock position, check
that all the passenger's power window switch illumi–
nations go out.
If operation is not as specified, replace the master
switch.
One Touch Power Window System/ Current of Cir–
cuit
Inspection using an ammeter.
(a) Disconnect the connector from the master switch.
(b) Connect the positive (+) lead from the ammeter to
terminal 6 on the wire harness side connector and the
negative (–) lead to negative terminal of the battery.
(c) Connect the positive (+) lead from the battery to
terminal 13 on the wire harness side connector.
(d) As the window goes down, check that the current
flow is approximately 7 A.
(e) Check that the current increases approximately 14.5
A or more when the window stops going down.
HINT: The circuit breaker opens some 4 – 40 seconds
after the window stops going down, so that check
must be made before the circuit breaker operates.
If the operation is as specified, replace the master
switch.
Inspection using an ammeter with a current–meas–
uring probe.
(a) Remove the master switch with connector connected.
(b) Attach a current–measuring probe to terminal 6 of
the wire harness.
(c) Turn the ignition switch ON and set the power
window switch in the down position.
(d) As the window goes down, check that the current
flow is approximately 7 A.
– POWER WINDOW CONTROL SYSTEM