Capture Bgp-Pdu Neighbor - Dell Z9500 Reference Manual

Related clear ip bgp
Commands

capture bgp-pdu neighbor

Enable capture of an IPv4 BGP neighbor packet.
Z9500
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx |
tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-
pdu neighbor ipv4-address command.
Parameters
ipv4-address
direction {both
| rx | tx}
Defaults Not configured.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.5.1.0
Related
capture bgp-pdu max-buffer-size
Commands
show capture bgp-pdu neighbor
364
— activates inbound policies without resetting the BGP TCP session.
Enter the IPv4 address of the target BGP neighbor.
Enter the keyword direction and a direction — either rx
for inbound, tx for outbound, or both.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
— specifies a size for the capture buffer.
— displays BGP packet capture information.
Border Gateway Protocol