Max-Concurrent-Dd (Ipv6 Ospf) - Allied Telesis AR2050V Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
- - (IP 6 OSPF)
MAX CONCURRENT DD V

max-concurrent-dd (IPv6 OSPF)

Overview Use this command to limit the number of neighbors that can be concurrently
processed in the database exchange. The specified value limits the number of
neighbors from all interfaces, not per interface.
Use the no variant of this command to have no limit on the maximum number of
LSAs.
max-concurrent-dd <max-neighbors>
Syntax
no max-concurrent-dd
Mode Router Configuration
Usage This command is useful where bringing up several adjacencies on a router is
affecting performance. In this situation, you can often enhance the system
performance by limiting the number of neighbors that can be processed
concurrently.
Example The following example sets the max-concurrent-dd value to allow only 4
neighbors to be processed at a time.
awplus#
awplus(config)#
awplus(config-router)#
Related router ipv6 ospf
Commands
C613-50186-01 Rev B
Parameter Description
<max-neighbors> <1-65535> The maximum number of neighbors.
configure terminal
router ipv6 ospf
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
max-concurrent-dd 4
1057