Timers (Bgp) - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
(BGP)
TIMERS

timers (BGP)

Overview Use this command sets the BGP keepalive timer and holdtime timer values.
Use the no variant of this command to reset timers to the default.
Syntax timers bgp <keepalive> <holdtime>
no timers bgp [<keepalive> <holdtime>]
Default The keepalive timer default is 60 seconds, the holdtime timer default is 90 seconds,
and the connect timer default is 120 seconds as per RFC 4271. Holdtime is
keepalive * 3.
Mode Router Configuration
Usage This command is used globally to set or unset the keepalive and holdtime values
for all the neighbors.
awplus#
Examples
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
Related neighbor timers
Commands
show ip bgp neighbors hold-time (BGP only)
show ip bgp neighbors keepalive-interval (BGP only)
C613-50186-01 Rev B
Parameter Description
<keepalive> <0-65535> The frequency with which the keepalive messages are
sent to the neighbors. The default is 30 seconds as per RFC 4271.
Cisco IOS uses a 60 second keepalive timer default value. Adjust
keepalive timers for interoperability as required. Maintain the
keepalive value at the holdtime value / 3.
<holdtime> <0-65535> The interval after which the neighbor is considered
dead if keepalive messages are not received. The default
holdtime value is 90 seconds as per RFC 4271.
Cisco IOS uses a 180 second holdtime timer default value. Adjust
holdtime timers for interoperability as required. Maintain the
holdtime value at the keepalive value * 3.
configure terminal
router bgp 10
configure terminal
router bgp 10
configure terminal
router bgp 10
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
timers bgp 40 120
no timers bgp 30 90
no timers bgp
1379