Passive-Interface (Rip) - Allied Telesis AR2050V Command Reference Manual

RIP C
OMMANDS
- (RIP)
PASSIVE INTERFACE

passive-interface (RIP)

Overview Use this command to block RIP broadcasts on the interface.
Use the no variant of this command to disable this function.
Syntax passive-interface <interface>
no passive-interface <interface>
Default Disabled
Mode RIP Router Configuration or RIP Router Address Family Configuration for a VRF
instance.
Example Use the following commands to block RIP broadcasts on vlan20:
awplus#
awplus(config)#
awplus(config-router)#
Example To apply this above example to a specific VRF instance named 'green', use the
(VRF-lite) following commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
Related show ip rip
Commands
Command Version 5.4.6-2.1: VRF-lite support added.
changes
C613-50186-01 Rev B
Parameter Description
<interface>
Specifies the interface name.
configure terminal
router rip
configure terminal
router rip
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
passive-interface vlan20
address-family ipv4 vrf green
passive-interface vlan20
851