Local-Proxy-Arp - Allied Telesis AR2050V Command Reference Manual

IP A P
DDRESSING AND ROTOCOL
- -
LOCAL PROXY ARP

local-proxy-arp

Overview Use this command to specify an IP subnet for use with limited local proxy ARP.
When limited local proxy ARP is enabled with the command
limited-local-proxy-arp, the device will respond to ARP requests for addresses in
that subnet.
Use the no variant of this command to stop specifying a subnet for use with limited
local proxy ARP.
local-proxy-arp [<ip-add/mask>]
Syntax
no local-proxy-arp [<ip-add/mask>]
Default No subnets are specified for use with limited local proxy ARP.
Mode Global Configuration
Example To specify limited local proxy ARP for the address 172.22.0.3, use the following
commands:
awplus#
awplus(config)#
This is part of a configuration snippet that shows how to use limited local proxy
ARP with static NAT. See the command
example.
Related ip limited-local-proxy-arp
Commands
C613-50186-01 Rev B
C
OMMANDS
Parameter Description
<ip-add/mask>
The IP subnet to use with limited local proxy ARP, in dotted
decimal format (A.B.C.D/M). To specify a single IP address, use a
32-bit mask.
configure terminal
local-proxy-arp 172.22.0.3/32
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip
ip limited-local-proxy-arp for the whole
680