Neighbor Transparent-Nexthop - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
-
NEIGHBOR TRANSPARENT NEXTHOP

neighbor transparent-nexthop

Overview Use this command to keep the next hop value of the route even if the BGP or
BGP4+ peer is an eBGP peer.
Note this command has the same effect as invoking
attribute-unchanged
Syntax neighbor <neighborid> transparent-nexthop
Mode Router Configuration
awplus#
Examples [BGP]
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router)#
awplus(config-router)#
awplus(config-router)#
C613-50186-01 Rev B
and specifying the optional next-hop parameter.
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address>
<ipv6-addr>
<peer-group>
configure terminal
router bgp 10
configure terminal
router bgp 10
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
neighbor
Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
command, and neighbor route-map
When this parameter is used with this
command, the command applies on all peers in
the specified group.
neighbor 10.10.10.1 transparent-nexthop
neighbor group1 peer-group
neighbor 10.10.10.1 remote-as 10
neighbor 10.10.10.1 peer-group group1
neighbor group1 transparent-nexthop
command.
1290