Allied Telesis AR2050V Command Reference Manual page 1426

P - R C
OLICY BASED OUTING OMMANDS
6 -
IPV POLICY ROUTE
Before creating a policy route, you need to create the application and entities that
specify the traffic you want to route. To create an application, use the
command. To create entities, use the zone,
commands. To see existing applications and entities, use the
show entity
Examples To create a policy route to route traffic that matches an application called "voice",
comes from the entity called "inside", and is destined for the entity called "outside",
use the following commands:
awplus#
awplus(config)#
awplus(config-pbr)#
awplus(config-pbr)#
inside to outside nexthop 2001:100::1
To delete the policy route created above, use the following commands:
awplus#
awplus(config)#
awplus(config-pbr)#
To route the above traffic via ppp0 if ppp0 is up, or ppp1 if ppp0 is down, use the
following commands:
awplus#
awplus(config)#
awplus(config-pbr)#
awplus(config-pbr)#
inside to outside nexthop ppp0 ppp1
To delete the policy route created above, use the following commands:
awplus#
awplus(config)#
awplus(config-pbr)#
Related policy-based-routing
Commands
policy-based-routing enable
show application
show entity
show ipv6 pbr route
C613-50186-01 Rev B
commands.
configure terminal
policy-based-routing
policy-based-routing enable
ipv6 policy-route 10 match voice from
configure terminal
policy-based-routing
no ipv6 policy-route 10
configure terminal
policy-based-routing
policy-based-routing enable
ipv6 policy-route 20 match voice from
configure terminal
policy-based-routing
no ipv6 policy-route 20
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
network (Entity), and host (Entity)
show application
application
and
1426