Arp-Aging-Timeout - Allied Telesis AR2050V Command Reference Manual

IP A P
DDRESSING AND ROTOCOL
- -
ARP AGING TIMEOUT

arp-aging-timeout

Overview This command sets a timeout period on dynamic ARP entries associated with a
specific interface. If your device stops receiving traffic for the host specified in a
dynamic ARP entry, it deletes the ARP entry from the ARP cache after this timeout
is reached.
Your device times out dynamic ARP entries to ensure that the cache does not fill
with entries for hosts that are no longer active. Static ARP entries are not aged or
automatically deleted.
By default the time limit for dynamic ARP entries is 300 seconds on all interfaces.
The no variant of this command sets the time limit to the default of 300 seconds.
arp-aging-timeout <0-432000>
Syntax
no arp-aging timeout
Default 300 seconds (5 minutes)
Mode Interface Configuration for a VLAN interface.
To set the ARP entries on interface vlan30 to time out after two minutes, use the
Example
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related clear arp-cache
Commands
show arp
C613-50186-01 Rev B
C
OMMANDS
Parameter Description
<0-432000>
The timeout period in seconds.
configure terminal
interface vlan30
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
arp-aging-timeout 120
648