Bgp Nexthop-Trigger Delay - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
-
BGP NEXTHOP TRIGGER DELAY

bgp nexthop-trigger delay

Overview Use this command to set the delay interval for next hop address tracking.
Use the no variant of this command to reset the timer value to the default.
Syntax bgp nexthop-trigger delay <1-100>
no bgp nexthop-trigger delay
Default The default next hop delay interval is 5 seconds.
Mode Global Configuration
Usage This command configures the delay interval between routing table waits for next
hop delay tracking. The delay interval determines how long BGP waits after it
receives the trigger from the system about one or more next hop changes before
it walks the full BGP table to determine which prefixes are affected by the next hop
changes.
Example To set the next hop delay interval to 6 seconds, enter the command:
awplus#
awplus(config)#
Related bgp nexthop-trigger-count
Commands
bgp nexthop-trigger enable
C613-50186-01 Rev B
Parameter
<1-100>
configure terminal
bgp nexthop-trigger delay 6
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Next hop trigger delay interval in seconds.
1144