Default-Metric (Rip) - Allied Telesis AR2050V Command Reference Manual

RIP C
OMMANDS
- (RIP)
DEFAULT METRIC

default-metric (RIP)

Overview Use this command to specify the metrics to be assigned to redistributed RIP routes.
Use the no variant of this command to reset the RIP metric back to its default (1).
Syntax default-metric <metric>
no default-metric [<metric>]
Default By default, the RIP metric value is set to 1.
Mode RIP Router Configuration or RIP Router Address Family Configuration for a VRF
instance.
Usage This command is used with the
protocol use the specified metric value for all redistributed routes, regardless of
the original protocol that the route has been redistributed from.
Examples This example assigns the cost of 10 to the routes that are redistributed into RIP.
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router)#
awplus(config-router)#
Example This example assigns the cost of 10 to the routes which are redistributed into RIP
(VRF-lite) for the VRF instance blue.
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
awplus(config-router-af)#
awplus(config-router-af)#
Related redistribute (RIP)
Commands
Command Version 5.4.6-2.1: VRF-lite support added.
changes
C613-50186-01 Rev B
Parameter Description
<metric>
<1-16> Specifies the value of the default metric.
configure terminal
router rip
configure terminal
router rip
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
redistribute (RIP) command to make the routing
default-metric 10
redistribute ospf
redistribute connected
address family ipv4 vrf blue
default-metric 10
redistribute ospf
redistribute connected
824