Neighbor Peer-Group (Add A Neighbor) - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
- (
NEIGHBOR PEER GROUP ADD A NEIGHBOR

neighbor peer-group (add a neighbor)

Overview Use this command to add a BGP or a BGP4+ neighbor to an existing peer-group.
Use the no variant of this command to disable this function.
Syntax [BGP] neighbor <ip-address> peer-group <peer-group>
no neighbor <ip-address> peer-group <peer-group>
neighbor <ipv6-addr> peer-group <peer-group>
Syntax [BGP4+]
no neighbor <ipv6-addr> peer-group <peer-group>
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] IPv6 Address Family Configuration
Usage Use this command to add neighbors with the same update policies to a peer
group. This facilitates the updates of various policies, such as, distribute and filter
lists. The peer-group is then configured easily with many of the neighbor
commands. Any changes made to the peer group affect all members.
To create a peer-group use the
command to add neighbors to the group.
This example shows a new peer-group group1 and the addition of a neighbor
Examples [BGP]
10.10.0.63 to the group.
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router)#
C613-50186-01 Rev B
)
Parameter Description
<ip-address> Specify the IPv4 address of the BGP neighbor, entered in the format
A.B.C.D.
<ipv6-addr>
Specify the IPv6 address of the BGP4+ neighbor, entered in
hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of the peer-group. When this parameter is used with
this command, the command applies on all peers in the specified
group.
configure terminal
router bgp 10
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
neighbor port command and then use this
neighbor group1 peer-group
neighbor 10.10.0.63 peer-group group1
1255