Debug Ip Packet Interface - Allied Telesis AR2050V Command Reference Manual

IP A P
DDRESSING AND ROTOCOL

DEBUG IP PACKET INTERFACE

debug ip packet interface
Overview The debug ip packet interface command enables IP packet debug and is
controlled by the terminal monitor command.
If the optional icmp keyword is specified then ICMP packets are shown in the
output.
The no variant of this command disables the debug ip interface command.
debug ip packet interface {<interface-name>|all} [address
Syntax
<ip-address>|verbose|hex|arp|udp|tcp|icmp]
no debug ip packet interface [<interface-name>]
Mode Privileged Exec and Global Configuration
C613-50186-01 Rev B
C
OMMANDS
Parameter Description
<interface>
Specify a single Layer 3 interface name (not a range of interfaces)
This keyword can be specified as either all or as a single Layer 3
interface to show debugging for either all interfaces or a single
interface.
all
Specify all Layer 3 interfaces on the device.
<ip-address>
Specify an IPv4 address.
If this keyword is specified, then only packets with the specified IP
address as specified in the ip-address placeholder are shown in the
output.
verbose
Specify verbose to output more of the IP packet.
If this keyword is specified then more of the packet is shown in the
output.
hex
Specify hex to output the IP packet in hexadecimal.
If this keyword is specified, then the output for the packet is shown
in hex.
arp
Specify arp to output ARP protocol packets.
If this keyword is specified, then ARP packets are shown in the
output.
udp
Specify udp to output UDP protocol packets.
If this keyword is specified then UDP packets are shown in the
output.
tcp
Specify tcp to output TCP protocol packets.
If this keyword is specified, then TCP packets are shown in the
output.
icmp
Specify icmp to output ICMP protocol packets.
If this keyword is specified, then ICMP packets are shown in the
output.
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
659