Match Tag - Allied Telesis AR2050V Command Reference Manual

R M C
OUTE AP OMMANDS

MATCH TAG

match tag
Overview Use this command to add a tag match clause to a route map entry. Specify the
route tag value to match.
An OSPF route matches the route map if it has been tagged with the route map's
tag value. Routes can be tagged through OSPF commands or through another
route map's set clause.
Each entry of a route map can only match against one tag in one match clause. If
the route map entry already has a tag match clause, entering this command
replaces that match clause with the new clause.
Use the no variant of this command to remove the tag match clause from the route
map entry.
match tag <0-4294967295>
Syntax
no match tag [<0-4294967295>]
Mode Route-map Configuration
Usage This command is valid for OSPF routes only.
To add entry 10 to the route map called mymap1, which will process routes that are
Example
tagged 100, use the following commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related match interface
Commands
match ip address
match ip next-hop
match route-type
route-map
set tag
show route-map
C613-50186-01 Rev B
configure terminal
route-map mymap1 permit 10
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
match tag 100
1396