Neighbor Next-Hop-Self - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
- -
NEIGHBOR NEXT HOP SELF

neighbor next-hop-self

Overview Use this command to configure the BGP or BGP4+ router as the next hop for a BGP
or BGP4+ speaking neighbor or peer group.
Use the no variant of this command to disable this feature.
Syntax neighbor <neighborid> next-hop-self
no neighbor <neighborid> next-hop-self
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] IPv6 Address Family Configuration
Usage This command allows a BGP or BGP4+ router to change the next hop information
that is sent to the iBGP peer. The next hop information is set to the IP address of the
interface used to communicate with the neighbor.
This command can be run for a specific VRF instance.
C613-50186-01 Rev B
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address>
<ipv6-addr>
<peer-group>
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
command, and neighbor route-map
When this parameter is used with this
command, the command applies on all peers in
the specified group.
command.
1244