Pppoe-Ac-Service - Allied Telesis AR2050V Command Reference Manual

PPP E (PPP E) C
OVER THERNET O
- -
PPPOE AC SERVICE

pppoe-ac-service

Overview Use this command to attach the specified PPPoE Access Concentrator (AC) service
to the interface. An AC service can be offered on several interfaces. Up to six PPPoE
AC services can be set for one interface. Only ETH and VLAN interfaces accept this
command.
Use the no variant of this command to remove the AC service from the interface.
pppoe-ac-service <label>
Syntax
no pppoe-ac-service <label>
Default No PPPoE AC service is attached to an interface by default.
Mode Interface Configuration
Usage The label of the PPPoE AC service specified in this command is created by the
pppoe-ac command.
Example To provide a PPPoE AC service labeled 'ISP-service' for client requests received on
interface eth1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove the PPPoE AC service 'isp1' from interface eth1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related pppoe-ac
Commands
C613-50186-01 Rev B
OMMANDS
Parameter Description
<label>
The name (label) of the PPPoE AC service to be attached to the
interface.
configure terminal
interface eth1
configure terminal
interface eth1
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
pppoe-ac-service ISP-service
no pppoe-ac-service isp1
632