Ip Extcommunity-List Standard - Allied Telesis AR2050V Command Reference Manual

BGP BGP4+ C
AND OMMANDS
-
IP EXTCOMMUNITY LIST STANDARD

ip extcommunity-list standard

Overview Use this command to create and delete a standard extended community list.
Use the no variant of this command to delete a standard extended community-list
entry.
Syntax ip extcommunity-list <1-99> {deny|permit} {rt|soo}
<community-number>
ip extcommunity-list standard <standard-listname> {deny|permit}
{rt|soo} <community-number>
no ip extcommunity-list <1-99> [{deny|permit} {rt|soo}
<community-number>]
no ip extcommunity-list standard <standard-listname>
[{deny|permit} {rt|soo} <community-number>]
Mode Global Configuration
C613-50186-01 Rev B
Parameter
<1-99>
standard
<standard-listname>
deny
permit
rt
soo
<community-number>
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Standard extcommunity list number.
Specifies a standard extended community list.
Standard extended community list entry.
Specifies the extended community to reject.
Specifies the extended community to accept.
Specifies the route target of the extended community.
Specifies the site of origin of the extended community.
Specifies the valid value for an extended community
number.
This can be one of two formats:
• <ASN:NN> where ASN is an AS (Autonomous System)
number and NN is a value chosen by the ASN
administrator
• <A.B.C.D:NN> where A.B.C.D is an IPv4 address, and
NN is a value chosen by the ASN administrator.
Note that ASN and NN are both integers from 1 to
4294967295.
AS numbers are assigned to the regional registries by
IANA (www.iana.org) and must be obtained in your
region.
1183