Peer Neighbor-Route - Allied Telesis AR2050V Command Reference Manual

PPP C
OMMANDS
-
PEER NEIGHBOR ROUTE

peer neighbor-route

Overview Use this command in Interface Configuration mode for a PPP interface to re-enable
the creation of peer neighbor routes after the default behavior has been disabled.
Use the no form of this command in Interface Configuration mode for a PPP
interface to disable the default behavior of creating a neighbor route for the peer.
Syntax peer neighbor-route
no peer neighbor-route
Default A 32-bit host route (with a /32 mask) is created to the peer address on a PPP
interface after PPP IPCP negotiation finishes.
Usage Use the no form of this command if the default behavior creates issues within your
network. Use the
issuing this command.
Mode Interface Configuration for a PPP interface
To re-enable the default behavior for the PPP interface ppp1, where a 32-bit host
Examples
route (with a /32 mask) is created to the peer address on a PPP interface after PPP
IPCP negotiation finishes, enter the commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable the default behavior for the PPP interface ppp0, to prevent a 32-bit host
route being added to the IP router table, enter the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show interface (PPP)
Commands
show ip route
Output Figure 19-5: Example validation output from the show interface and show ip
C613-50186-01 Rev B
show ip route command to validate the route behavior after
configure terminal
interface ppp1
peer neighbor-route
configure terminal
interface ppp0
no peer neighbor-route
route commands issued before and after the no peer
neighbor-route command (see IPv4 address in show interface
output and see connected routes show ip route output):
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
596