Ipv6 Ospf Dead-Interval - Allied Telesis AR2050V Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
6 -
IPV OSPF DEAD INTERVAL

ipv6 ospf dead-interval

Overview This command sets the interval during which no hello packets are received and
after which a neighbor is declared dead.
The dead-interval is the amount of time that OSPF waits to receive an OSPF hello
packet from the neighbor before declaring the neighbor is down. This value is
advertised in the router's hello packets. It must be a multiple of the hello-interval
and be the same for all routers on a specific network.
The no variant of this command returns the interval to the default of 40 seconds.
ipv6 ospf dead-interval <1-65535> [<inst-id>]
Syntax
no ipv6 ospf
Mode Interface Configuration for a VLAN interface or Interface Configuration for a PPP
interface.
Example The following example shows configuring the dead-interval to 10 seconds on the
VLAN interface vlan2:
awplus#
awplus(config)#
awplus(config-if)#
The following example shows configuring the dead-interval to 10 seconds on the
PPP interface ppp0:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 ospf hello-interval
Commands
show ipv6 ospf interface
C613-50186-01 Rev B
dead-interval
Parameter Description
<1-65535>
The interval in seconds.
Default: 40
<inst-id>
The instance ID
Default: 0
configure terminal
interface vlan2
configure terminal
interface ppp0
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 ospf dead-interval 10
ipv6 ospf dead-interval 10
1043