Show Ipv6 Pbr Route - Allied Telesis AR2050V Command Reference Manual

P - R C
OLICY BASED OUTING OMMANDS
6
SHOW IPV PBR ROUTE

show ipv6 pbr route

Overview Use this command to display the installed IPv6 routes for policy-based routing.
show ipv6 pbr route [<1-128>]
Syntax
Mode User Exec/Privileged Exec
Usage If you do not specify a policy routeID, the output starts by listing the ordinary static
and dynamic routes, in a table called "main".
Example To show all the IPv6 routes, use the following command:
awplus#
Output Figure 31-3: Example output from show ipv6 pbr route
If you do not specify a policy routeID, the output starts by listing the ordinary static
and dynamic routes, in the route table called "main".
Then it lists the routes for each policy route.
For each route, the output lists the route's next-hop IPv6 address and/or the
next-hop interface.
Example To show only the routes for policy-route 20, use the following command:
awplus#
C613-50186-01 Rev B
Parameter Description
<1-128>
The policy route ID. If you specify a policy route ID, the output
only lists routes for that ID. If you do not specify an ID, the output
also lists the ordinary static and dynamic routes, in the table
called "main".
show ipv6 pbr route
awplus#show ipv6 pbr route 
Route table: main 
2001:100::/64 dev eth1 
fe80::/64 dev eth1

Route table: policy-route 10 

Route table: policy-route 20 
default via 2001:100::2, eth1
show ip pbr route 20
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x

1431