Version (Rip) - Allied Telesis AR2050V Command Reference Manual

VRF- C
LITE OMMANDS
(RIP)
VERSION

version (RIP)

Overview Use this command to specify a RIP version used globally by the router.
If VRF-lite is configured, you can specify a RIP version either globally, or for a
particular VRF instance.
Use the no variant of this command to restore the default version.
version {1|2}
Syntax
no version
Default Version 2
Mode RIP Router Configuration or RIP Router Address Family Configuration for a VRF
instance.
Usage RIP can be run in version 1 or version 2 mode. Version 2 has more features than
version 1; in particular RIP version 2 supports authentication and classless routing.
Once the RIP version is set, RIP packets of that version will be received and sent on
all the RIP-enabled interfaces.
Setting the version command has no impact on receiving updates, only on
sending them. The
version (RIP)
command allows you to configure a specific interface to accept only packets of the
specified RIP version. The
version
Examples To specify a RIP version, use the following commands:
awplus#
awplus(config)#
awplus(config-router)#
To specify a RIP version with VRF, use the following commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
Related ip rip receive version
Commands
ip rip send version
show running-config
C613-50186-01 Rev B
Parameter Description
1|2
Specifies the version of RIP processing.
ip rip send version
command on an interface-specific basis. The
command override the value set by this command.
configure terminal
router rip
configure terminal
router rip
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
command overrides the value set by the
ip rip receive version command and the
version 1
address-family ipv4 vrf blue
version 1
ip rip receive version
ip rip send
1543