Address-Family Ipv4 (Rip) - Allied Telesis AR2050V Command Reference Manual

VRF- C
LITE OMMANDS
- 4 (RIP)
ADDRESS FAMILY IPV

address-family ipv4 (RIP)

Overview This command enters the IPv4 address-family command mode. In this mode you
can configure address-family specific parameters for a specific VRF (RIP) instance.
address-family ipv4 vrf <vrf-name>
Syntax
no address-family ipv4 vrf <vrf-name>
Mode Router Configuration
Usage To leave Address Family mode and return to Router Configuration mode, use the
exit-address-family
Example In this example the address family "green" is entered, and then exited by using the
exit-address-family command.
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
awplus(config-router)#
Related exit-address-family
Commands
Command Version 5.4.6-2.1: VRF-lite support added.
changes
C613-50186-01 Rev B
Parameter Description
ipv4
Configure parameters relating to the RIP exchange of IPv4 prefixes.
vrf
Apply this command to a VRF instance.
<vrf-name>
The name of the VRF instance.
command.
configure terminal
router rip
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
address-family ipv4 vrf green
exit-address-family
1440