Ip Ospf Transmit-Delay - Allied Telesis AR2050V Command Reference Manual

OSPF C
OMMANDS
-
IP OSPF TRANSMIT DELAY

ip ospf transmit-delay

Overview Use this command to set the estimated time it takes to transmit a link-state-update
packet on the VLAN interface.
Use the no variant of this command to return to the default of 1 second.
Syntax ip ospf [<ip-address>] transmit-delay <1-65535>
no ip ospf [<ip-address>] transmit-delay
Default The default interval is 1 second.
Mode Interface Configuration for a VLAN interface or a PPP interface.
Usage The transmit delay value adds a specified time to the age field of an update. If the
delay is not added, the time in which the LSA transmits over the link is not
considered. This command is especially useful for low speed links. Add
transmission and propagation delays when setting the transmit delay value.
Example The following example shows setting the OSPF transmit delay time to 3 seconds on
the VLAN interface vlan2.
awplus#
awplus(config)#
awplus(config-if)#
The following example shows setting the OSPF transmit delay time to 3 seconds on
the PPP interface ppp0.
awplus#
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
Parameter Description
<ip-address>
The IP address of the VLAN interface.
<1-65535>
Specifies the time, in seconds, to transmit a link-state update.
configure terminal
interface vlan2
configure terminal
interface ppp0
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip ospf transmit-delay 3
ip ospf transmit-delay 3
949