Match Route-Type - Allied Telesis AR2050V Command Reference Manual

R M C
OUTE AP OMMANDS
-
MATCH ROUTE TYPE

match route-type

Overview Use this command to add an external route-type match clause to a route map
entry. Specify whether to match OSPF type-1 external routes or OSPF type-2
external routes.
An OSPF route matches the route map if its route type matches the route map's
route type.
Each entry of a route map can only match against one route type in one match
clause. If the route map entry already has a route type match clause, entering this
command replaces that match clause with the new clause.
Use the no variant of this command to remove the route type match clause from
the route map entry.
match route-type external {type-1|type-2}
Syntax
no match route-type external [type-1|type-2]
Mode Route-map Configuration
Usage Use the match route-type externalcommand to match specific external route
types. AS- external LSA is either Type-1 or Type-2. external type-1 matches only
Type 1 external routes, and external type-2 matches only Type 2 external routes.
This command is valid for OSPF routes only.
To add entry 10 to the route map called mymap1, which will process type-1
Example
external routes, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related match interface
Commands
match ip address
match ip next-hop
match tag
route-map
set metric-type
show route-map
C613-50186-01 Rev B
Parameter Description
type-1
OSPF type-1 external routes.
type-2
OSPF type-2 external routes.
configure terminal
route-map mymap1 permit 10
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
match route-type external type-1
1395