Ipv6 Nd Reachable-Time - Allied Telesis AR2050V Command Reference Manual

IP 6 C
V OMMANDS
6 -
IPV ND REACHABLE TIME

ipv6 nd reachable-time

Overview Use this command to specify the reachable time in the router advertisement to be
used for detecting reachability of the IPv6 neighbor.
Use the no variant of this command to reset the value to default.
Syntax ipv6 nd reachable-time <milliseconds>
no ipv6 nd reachable-time
Default 0 milliseconds
Mode Interface Configuration for a VLAN interface or a PPP interface.
Usage This command specifies the reachable time of the current router to be announced
in IPv6 Router Advertisements.
Advertisement flags will not be transmitted unless you have applied the
suppress-ra
To set the reachable-time in router advertisements on the VLAN interface vlan4
Example
to be 1800000 milliseconds, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To reset the reachable-time in router advertisements on the VLAN interface vlan4
to an unspecified reachable-time (0 milliseconds), enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the reachable-time in router advertisements on the PPP interface ppp0 to
be 1800000 milliseconds, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To reset the reachable-time in router advertisements on the PPP interface ppp0 to
an unspecified reachable-time (0 milliseconds), enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
command. This instruction is included in the example shown below.
configure terminal
interface vlan4
ipv6 nd reachable-time 1800000
no ipv6 nd suppress-ra
configure terminal
interface vlan4
no ipv6 nd reachable-time
configure terminal
interface ppp0
ipv6 nd reachable-time 1800000
no ipv6 nd suppress-ra
configure terminal
interface ppp0
no ipv6 nd reachable-time
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 nd
775