Allied Telesis AR2050V Command Reference Manual page 1525

VRF- C
LITE OMMANDS
SHOW IP ROUTE
To display all routing entries in the FIB associated with a VRF instance red, use the
Example
(VRF-lite) command:
awplus#
Output Each entry in the output from this command has a code preceding it, indicating the
source of the routing entry. For example, O indicates OSPF as the origin of the
route. The first few lines of the output list the possible codes that may be seen with
the route entries.
Typically, route entries are composed of the following elements:
•
•
•
•
•
•
•
Figure 32-14: Example output from the show ip route command
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
* - candidate default

O 10.10.37.0/24 [110/11] via 10.10.31.16, vlan2, 00:20:54
C 3.3.3.0/24 is directly connected, vlan1
C 10.10.31.0/24 is directly connected, vlan2
C 10.70.0.0/24 is directly connected, vlan4
O E2 14.5.1.0/24 [110/20] via 10.10.31.16, vlan2, 00:18:56
C 33.33.33.33/32 is directly connected, lo
Connected Route The connected route entry consists of:
This route entry denotes:
•
•
OSPF Route The OSPF route entry consists of:
C613-50186-01 Rev B
show ip route vrf red
code
a second label indicating the sub-type of the route
network or host IP address
administrative distance and metric
next hop IP address
outgoing interface name
time since route entry was added
C 10.10.31.0/24 is directly connected, vlan2
Route entries for network 10.10.31.0/24 are derived from the IP address
of local interface vlan2.
These routes are marked as Connected routes (C) and always preferred
over routes for the same network learned from other routing protocols.
O 10.10.37.0/24 [110/11] via 10.10.31.16, vlan2, 00:20:54
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1525