Proxy-Auth - Allied Telesis AR2050V Command Reference Manual

PPP E (PPP E) C
OVER THERNET O
-
PROXY AUTH

proxy-auth

Overview Use this command to enable the proxy authentication to allow PPP authentication
data to be collected and sent to an L2TP peer in additional L2TP AVPs when the
L2TP session is established.
Use the no variant of this command to disable the proxy authentication.
Syntax proxy-auth
no proxy-auth
Default Proxy authentication is enabled by default.
Mode PPPoE Access Concentrator Configuration
Example To enable proxy authentication for the PPPoE AC service "ISP-service", use the
commands:
awplus#
awplus(config)#
awplus(config-pppoe-ac)#
Disable proxy authentication for PPPoE AC service "ISP-service:
awplus#
awplus(config)#
awplus(config-pppoe-ac)#
Related destination l2tp
Commands
l2tp peer-address dns-lookup
l2tp peer-address radius-lookup group
ppp-auth-protocol
pppoe-ac-service
service-name
show running-config pppoe-ac
C613-50186-01 Rev B
OMMANDS
configure terminal
pppoe-ac ISP-service
configure terminal
pppoe-ac ISP-service
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
proxy-auth
no proxy-auth
633