Ppp Service-Name (Pppoe) - Allied Telesis AR2050V Command Reference Manual

PPP C
OMMANDS
- (PPP E)
PPP SERVICE NAME O

ppp service-name (PPPoE)

Overview This command configures the PPPoE service name used to select a service from an
access concentrator. This can only be applied when the PPP interface has been
configured over an underlying eth interface.
Use the no variant of this command to set the service name for the connection
back to the default (unset).
ppp service-name <service-name>
Syntax
no ppp service-name
Default The default option is not to specify a service name. This results in a connection to
the default service specified by the access concentrator.
Mode Interface Configuration for a PPP interface
Usage You can only apply a single service name to each PPPoE interface.
Examples To connect to a service called "Internet", use the command:
awplus(config)#
awplus(config-if)#
Related encapsulation ppp
Commands
show interface (PPP)
C613-50186-01 Rev B
Parameter Description
<service-name>
Specifies the PPPoE service name to select from an access
concentrator. The service-name is 1 to 18 characters long, is
case-sensitive, and for a PPPoE client is usually supplied by the
ISP.
The name can contain any printable ASCII characters (ASCII
32-126). If the name contains the special characters backslash,
double-quote or space, those characters should be escaped
with a backslash.
The default is no service name.
interface ppp0
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ppp service-name Internet
610