Destination L2Tp - Allied Telesis AR2050V Command Reference Manual

PPP E (PPP E) C
OVER THERNET O
2
DESTINATION L TP

destination l2tp

Overview Use this command to set the destination to forward all PPPoE packets to the peer
over L2TP.
Use the no variant of this command to unset the destination for PPPoE packets.
Syntax destination l2tp
no destination
Default This command is not configured by default.
Mode PPPoE Access Concentrator Configuration
Example To sets the destination to forward all PPPoE packets for the service 'ISP-service' to
the peer over L2TP, use the commands:
awplus#
awplus(config)#
awplus(config-pppoe-ac)#
To unset the destination for PPPoE packets for the service 'ISP-service', use the
commands:
awplus#
awplus(config)#
awplus(config-pppoe-ac)#
Related l2tp peer-address dns-lookup
Commands
l2tp peer-address radius-lookup group
l2tp peer-address static
l2tp profile
pppoe-ac
ppp-auth-protocol
service-name
show running-config pppoe-ac
C613-50186-01 Rev B
OMMANDS
configure terminal
pppoe-ac ISP-service
configure terminal
pppoe-ac ISP-service
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
destination l2tp
no destination
622