Ipv6 Nd Ra-Interval - Allied Telesis AR2050V Command Reference Manual

IP 6 C
V OMMANDS
6 -
IPV ND RA INTERVAL

ipv6 nd ra-interval

Overview Use this command to specify the interval between IPv6 Router Advertisements
(RA) transmissions.
Use no parameter with this command to reset the value to the default value (600
seconds).
Syntax ipv6 nd ra-interval <seconds>
no ipv6 nd ra-interval
Default 600 seconds.
Mode Interface Configuration for a VLAN interface or a PPP interface.
Usage Advertisement flags will not be transmitted unless you have applied the
suppress-ra
Example To set the advertisements interval on the VLAN interface "vlan4" to be 60 seconds,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 nd minimum-ra-interval
Commands
ipv6 nd suppress-ra
ipv6 nd prefix
C613-50186-01 Rev B
Parameter Description
<seconds>
Specifies the number of seconds between IPv6 Router
Advertisements (RAs). Valid values are from 4 to 1800 seconds.
command as shown in the example below.
configure terminal
interface vlan4
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 nd ra-interval 60
no ipv6 nd suppress-ra
ipv6 nd
773