Set Originator-Id - Allied Telesis AR2050V Command Reference Manual

R M C
OUTE AP OMMANDS
-
SET ORIGINATOR ID

set originator-id

Overview Use this command to add an originator ID set clause to a route map entry.
The originator ID is the router ID of the IBGP peer that first learned this route, either
via an EBGP peer or by some other means such as importing it.
When a BGP update message matches the route map entry, the device sets its
originator ID attribute to the specified value.
Use the no variant of this command to remove the set clause.
Syntax set originator-id <ip-address>
no set originator-id [<ip-address>]
Mode Route-map Configuration
Usage This command is valid for BGP update messages only.
To use entry 3 of the route map called rmap1 to give matching update messages
Example
an originator ID of 1.1.1.1, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related route-map
Commands
show route-map
C613-50186-01 Rev B
Parameter Description
<ip-address>
The IP address of the originator, entered in the form A.B.C.D.
configure terminal
route-map rmap1 permit 3
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
set originator-id 1.1.1.1
1417