Fullupdate (Rip) - Allied Telesis AR2050V Command Reference Manual

VRF- C
LITE OMMANDS
(RIP)
FULLUPDATE

fullupdate (RIP)

Overview Use this command to specify which routes RIP should advertise when performing
a triggered update. By default, when a triggered update is sent, RIP will only
advertise those routes that have changed since the last update. When fullupdate
is configured, the device advertises the full RIP route table in outgoing triggered
updates, including routes that have not changed. This enables faster convergence
times, or allows inter-operation with legacy network equipment, but at the
expense of larger update messages.
Use the no variant of this command to disable this feature.
fullupdate
Syntax
no fullupdate
Default By default this feature is disabled.
Mode RIP Router Configuration or RIP Router Address Family Configuration for a VRF
instance.
Usage (VRF-lite) If VRF-lite is configured, you can apply this command for either the global routing
environment, or to a specific VRF instance.
Example To enable the fullupdate (RIP) function, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
Example To enable the full update (RIP) function on the VRF instance named 'blue', use the
(VRF-lite) commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
Command Version 5.4.6-2.1: VRF-lite support added.
changes
C613-50186-01 Rev B
configure terminal
router rip
fullupdate
configure terminal
router rip
address-family ipv4 vrf blue
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
fullupdate
1459