Ipv6 Rip Split-Horizon - Allied Telesis AR2050V Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
6 -
IPV RIP SPLIT HORIZON

ipv6 rip split-horizon

Overview Use this command to perform the split-horizon action on the interface. The default
is split-horizon with poisoned reverse.
Use the no variant of this command to disable this function.
Syntax ipv6 rip split-horizon [poisoned]
no ipv6 rip split-horizon
Default Split-horizon with poisoned reverse is the default.
Mode Interface Configuration for a VLAN interface or a PPP interface.
Usage Use this command to avoid including routes in updates sent to the same gateway
from which they were learned. Using the split horizon command omits routes
learned from one neighbor, in updates sent to that neighbor. Using the poisoned
parameter with this command includes such routes in updates, but sets their
metrics to infinity. Thus, advertising that these routes are not reachable.
To perform split-horizon with poisoned reverse on the VLAN interface vlan2,
Examples
enter the below commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config)#
awplus(config-if)#
To disable split-horizon on the VLAN interface vlan2, enter the below commands:
awplus#
awplus(config)#
awplus(config-if)#
To perform split-horizon with poisoned reverse on the PPP interface ppp0, enter
the below commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
Parameter Description
split-horizon
Perform split-horizon without poisoned reverse
poisoned
Performs split-horizon with poisoned reverse.
configure terminal
router ipv6 rip
interface vlan2
configure terminal
interface vlan2
configure terminal
router ipv6 rip
interface ppp0
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
exit
ipv6 rip split-horizon poisoned
no ipv6 rip split-horizon
exit
ipv6 rip split-horizon poisoned
883