Network (Rip) - Allied Telesis AR2050V Command Reference Manual

VRF- C
LITE OMMANDS
(RIP)
NETWORK

network (RIP)

Overview Use this command to activate the transmission of RIP routing information on the
defined network.
Use the no variant of this command to remove the specified network or VLAN as
one that runs RIP.
Syntax network {<network-address>[/<subnet-mask>]|<vlan-name>}
no network {<network-address>[/<subnet-mask>]|<vlan-name>}
Default Disabled
Mode RIP Router Configuration or RIP Router Address Family Configuration for a VRF
instance.
Usage Use this command to specify networks, or VLANs, to which routing updates will be
sent and received. The connected routes corresponding to the specified network,
or VLANs, will be automatically advertised in RIP updates. RIP updates will be sent
and received within the specified network or VLAN.
When running VRF-lite, this command can be applied to a VRF instance.
Example Use the following commands to activate RIP routing updates on network
172.16.20.0/24:
awplus#
awplus(config)#
awplus(config-router)#
Example To activate RIP routing updates on vlan3 for VRF instance 'blue'.
(VRF-lite)
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router-af)#
C613-50186-01 Rev B
Parameter
<network-address>
[/<subnet-mask>]
<vlan-name>
configure terminal
router rip
configure terminal
router rip
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specifies the network address to run RIP. Entering a subnet
mask (or prefix length) for the network address is optional.
Where no mask is entered, the device will attempt to apply a
mask that is appropriate to the class (A, B, or C) of the
address entered, e.g. an IP address of 10.0.0.0 will have a
prefix length of 8 applied to it.
Specify a VLAN name with up to 32 alphanumeric characters
to run RIP.
network 172.16.20.0/24
address-family ipv4 vrf blue
network vlan3
1480