Set Tag - Allied Telesis AR2050V Command Reference Manual

R M C
OUTE AP OMMANDS

SET TAG

set tag
Overview Use this command to add a tag set clause to a route map entry.
When a route matches the route map entry, the device sets its tag to the specified
value when it redistributes the route into OSPF.
Use the no variant of this command to remove the set clause.
set tag <tag-value>
Syntax
no set tag [<tag-value>]
Mode Route-map Configuration
Usage This command is valid only when redistributing routes into OSPF.
To use entry 3 of the route map called rmap1 to tag matching routes with the
Example
number 6, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related default-information originate
Commands
redistribute (OSPF)
match tag
route-map
show route-map
C613-50186-01 Rev B
Parameter Description
<tag-value>
<0-4294967295>
Value to tag matching routes with.
configure terminal
route-map rmap1 permit 3
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
set tag 6
1418